Plug the input cord into a proper voltage receptacle with proper circuit capacity (See Chart under circuit requirements on page 1). Rotate the Wire Speed Control to setting number 5 to start with, then adjust as needed after test weld. Heat setting may vary according to welding conditions and materials. NOTE: These settings are general guidelines only. Wire Feed Arc Welder Operation (Continued) See application decal inside door of wire feed compartment for proper heat settings. Lens Lens Retainer Retainer Stiffener Figure 6 4. Attach the stiffeners over the pins on the lens retainers (See Figure 6). Trim the excess plastic to remove sharp edges. Cut retainer stiffeners and detachable handle away from shield. Handshield Assembly NOTE: Shielding gas is not required if flux-cored welding wire is used. Welding operations may continue when the yellow lamp is no longer illuminated. WG3013 Assembly (Continued) if the duty cycle is exceeded. Fasten screws through bracket and into cabinet. Place bracket on welder aligning the holes in welder housing. Secure wheel with e-clips and wheel caps. Insert axle through the axle supports and firmly push wheels onto axle. Insert axle supports into slots in the welder housing. Fasten screws through top cover and into handle. Wire Feed Arc Welder Assembly (Continued) and top cover aligning the holes in handle with holes in top cover. Do not perform electric arc welding operations on metals that are galvanized or cadmium plated, or contain zinc, mercury, or beryllium without completing the following precautions: a.Keep the head and face out of the welding fumes.If the welding area cannot be adequately ventilated, be sure to use an air supplied respirator. WG3013 General Safety (Continued) ! WARNING Do not breathe fumes that are produced by the arc welding operation. Failure to follow safety precautions or instructions can cause equipment damage and/or serious personal injury or death. Before starting or servicing any electric arc welder, read and understand all instructions.! WARNING ! WARNING Always keep a fire extinguisher accessible while performing arc welding operations. Wire Feed Arc Welder General Safety (Continued) Torch is “live” (has current potential) at all times when machine is turned on. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference. Protect yourself and others by observing all safety information. Read carefully before attempting to assemble, install, operate or maintain the product described. Model WG3013 Operating Instructions & Parts Manual Please read and save these instructions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |